Jewel tester buyers prefer this operation

DATE:2023-11-04

Jewel tester buyers prefer this operating method. Below, we recommend choosing me as your B460U-C probe. If you are interested in the B460U-C probe, please contact us and we will customize this functional product for you.

Data jitter during normal operation: Dual signal phase voltammeter: It is a combination of two cascade phase meters, one signal generator, and one analysis software. There are two types to choose from in the third generation, the first generation has this voltage output to measure the current, and the second generation has a second voltage output to measure the current. The second generation has a second generation voltage output that is amplified by an SPC magnifying lens and sent to an oscilloscope probe, an analysis software, and an oscilloscope probe SMNK for selection. Oscilloscope output: LDPS 70 storage space, 2/8-bit ADC (non periodic) waveform display, suitable for various measurement environments, can measure voltage, current signal, frequency signal, phase and other datasets, and clearly display the clarity, degree, and basic parameters of the waveform. Its calculated values and resolution are dedicated. The oscilloscope can conveniently display waveforms on the monitor and make judgments based on the waveforms. The waveform of the oscilloscope can be accurately planned and parameter set by using the oscilloscope. The oscilloscope can conveniently condense the simulation and other functional sets of the signal to be tested (D) onto the oscilloscope, achieving better waveform visualization. The simulation of an oscilloscope should cover basic commonly used waveform measurements without the need for other logical calculation methods.

Scope: The resolution of the oscilloscope is 1. The oscilloscope can be planned based on a special waveform (firmware, waveform recording, waveform, event, etc.). The waveform capture rate of the oscilloscope can accurately determine the processing terminal voltage and waveform of various parameters.

The basic control indicators of the oscilloscope include FOTRIC (pulse waveform), FC level spectrum, and multi bandwidth (MTF), STSP, HDI, TDR, and HDO of the oscilloscope;

View the trigger synchronization method (AR) and display the transient waveform of the trigger. Its value is the waveform (t) of non working voltage, such as dB value; Visible peak of signal; TDR; Resolution, T-N; T. Peak value; Vs value; The maximum number of experimental projects that can be completed within 5 working days, and the joy of completing validation;

View the frequency waveform being tested and compare it along the waveform (t) on the curve. The amplitude of the curve is f, and it can be compared clearly;

The waveform display mode of the device can be waveform output, manual or automatic arc. The frequency range of waveform output can be displayed in the form of a sine wave, and the entire scale can be monitored to determine whether it is stationary or has a signal.

Used to check the status of the computer, determine if it is stationary, and then determine if a malfunction has occurred. If such a malfunction does not occur in the future, it may cause safety accidents.

Used to check whether the empty contact and routing circuit connections of the signal are correct. The signal of the GPS signal grounding point generally refers to the position enclosed in a circle, and the spacing is determined to be internal or external. The connection error can be repaired or eliminated due to installation conditions.